7.5.2 Connecting the ETHERNET Port via a Network Hub (Straight-Through Cable)
You can connect the Ethernet port of the VS-66H to the Ethernet port on a
network hub or network router, via a straight through cable with RJ-45
connectors.
8 Technical Specifications
Table 2 includes the technical specifications:
Table 2: Technical Specifications
1
INPUTS:
of the VS-66H
6 HDMI Connectors
OUTPUTS: 6 HDMI Connectors
BANDWIDTH: Supports up to 1.65Gbps bandwidth per graphic channel
COMPLIANCE WITH HDMI
STANDARD:
Supports HDMI and HDCP
RESOLUTION: Up to UXGA; 1080p
POWER SOURCE:
100−240V AC; 50/60Hz, 32VA
CONTROLS: Front panel buttons, infrared remote control transmitter, RS-232, Ethernet
DIMENSIONS: 19” x 7” x 1U W, D, H
WEIGHT: 2.5kg (5.5lbs) approx.
ACCESSORIES: Power cord, rack “ears”, IR remote control
OPTIONS: Kramer HDMI cables
2
9 Communication Parameters
Table 3: Communication Parameters
RS-232
Protocol 2000
Baud Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Command Format: HEX
Example (Output 1 to Input 1): 0x01, 0x81, 0x81, 0x81
Ethernet
Default Settings Reset Ethernet Default Settings
IP Address: 192.168.1.39 Power cycle the unit while holding in the Factory Reset
button, located on the rear panel of the unit.
TCP Port #: 5000
1 Specifications are subject to change without notice
2 For best results, use Kramer cables such as the C-HM/HM series, the C-HM/DM series and/or our HDMI over fiber optics
C-FOHM/FOHM series
To Next Page
Loading...
