Kramer VS-66H

Your VS-66H 6x6 HDMI Matrix Switcher
7
Table 1: VS-66H 6x6 HDMI Matrix Switcher Features
#
Feature
Function
1 IR Receiver The red LED lights when receiving signals from the Infrared remote
control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 ALL Button Pressing ALL before pressing an input button, connects that input to
all outputs
1
4 OFF Button Pressing OFF after pressing an output button disconnects that output
from the inputs. To disconnect all the outputs,
press the ALL button and
then the OFF button
5 SELECT
Buttons
2
OUT Select the output to which the input is switched (from 1 to 6). The
selected button illuminates if an acceptor is connected
6 IN Select the input to switch to the output (from 1 to 6). The selected
button illuminates if a source is connected
7 STO Button Press to store an input setting (see section 7.3)
8 RCL Button Press to recall an input setting (see section 7.3)
9 LOCK Button Press to toggle disengaging the front panel buttons and to acquire
the EDID (see section
7.1)
10 EDID Button
3
Press to acquire the EDID (see section 7.1)
11 OUTPUT/ INPUT
LCD Display
Displays the selected input switched to the output (marked above
each input)
12 INPUT HDMI Connectors Connect to the HDMI sources (from 1 to 6)
13 OUTPUT HDMI Connectors Connect to the HDMI acceptors (from 1 to 6)
14 RS-232 9-pin D-sub Port Connects to the PC or other RS-232 Remote Controller
15 ETHERNET Connector Connects to the PC or other Ethernet Controller
16 RESET Button Press the ETHERNET factory reset button
to reset to the factory default
definitions
4
IP number − 192.168.1.39
:
Mask – 255.255.255.0
Gateway – 192.168.1.1
17 REMOTE IR Opening
5
Connects to an external IR receiver unit
6
18
for controlling the machine via an
IR remote controller (instead of using the front panel IR receiver)
Power Connector with Fuse AC connector enabling power supply to the unit
1 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
2 Are also used for storing machine setups (see section
7.3)
3 Illuminates when configuring the EDID
4 First turn the VS-66H OFF and then turn it ON again while pressing the RESET button. The unit will power up and load its
memory with the factory default definitions
5 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
6 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)