Page | 5
Introduction
Thank you for purchasing your ERGO Room Correction and Audio Interface system. If you are already a KRK thanks for
your continued use and support of our products. If you are new to KRK we are pleased that you chose ERGO as your
room correction, we welcome you to our continually growing number of users. At KRK we strive to achieve the most
honest, natural reproduction of your hard work. We encourage you to visit our website to see our industry standard
Rokit monitors, class leading VXT monitors, Subwoofer solutions and the latest addition to the KRK portfolio, the KNS
series headphones.
ERGO (Enhanced Room Geometry Optimization) is an exciting product that enhances the performance of any
loudspeaker/monitoring system by digitally correcting both common and complex acoustic problems in the room.
1. Method of Use
ERGO can be used in two main ways:
a. As an audio interface (with room correction) to hardware running Apple Mac OSX (Core Audio) or
Microsoft Windows (DirectX-WDM/ASIO) operating systems, allowing full access to audio input and outputs
for recording and monitoring, and room-correction.
b. As a stand-alone room correction device which sits “in-line” with your monitoring signal path. This
requires connection to your Apple Mac OSX or Microsoft Windows hardware for the room calibration process
only, once complete ERGO can be disconnected to use in stand-alone mode providing room correction to the
line input signal and supplying the corrected signal to your monitoring system
Both methods allow the following room correction options:
a. Dual Monitoring System
Two sets of stereo monitors which can be A/B switched from ERGO’s front panel
b. 2.1 Monitoring System
A single set of stereo monitors and a dedicated subwoofer, in this mode the main monitors and the
subwoofer can be individually muted when required
ERGO’s functionality is consistent between modes and all operational aspects are identical. For more on the
functionality please see the section on connecting ERGO.
To Next Page
Loading...