KRK ERGO - 19. Connecting ERGO to your computer; A. System Requirements; C. Power considerations

Page | 20
19. Connecting ERGO to your computer
System Requirements A.
Note: If using in Stand-Alone mode a connection to an Apple Mac OSX, or Microsoft windows computer is only
required for performing room measurement and analysis.
The Minimum required computer specifications for calibration or use as an audio interface (with room correction)
are listed below:
Microsoft Windows 7 (32/64-bit)
Microsoft Windows Vista (32/64-bit)
Microsoft Windows XP (SP2 or later) (32-bit)
1GB RAM, 10 MB hard disk space, 800 x 600 monitor resolution (or higher)
4 or 6-pin FireWire port (6-pin port required to FireWire to supply power to ERGO)
AC outlet (for ERGO power supply if power is not supplied via FireWire).
Apple Mac OSX 10.6.x (Snow Leopard 64-bit)
Apple Mac OSX 10.5.x (Leopard 32-bit)
Apple Mac 10.4.x is not supported, but can be utilized by using Apple FireWire driver 2.2.0.
1GB RAM, 10 MB hard disk space, 800 x 600 monitor resolution (or higher)
4 or 6-pin FireWire port (6-pin port required to FireWire to supply power to ERGO)
AC outlet (for ERGO power supply if power is not supplied via FireWire).
c. Power considerations
ERGO can be powered in two ways:
External Power Supply – This requires use of the supplied 12VDC/1A supply, which is included.
Firewire Bus Power – Using the power provided by the Firewire port (if available), please see more
information on Firewire bus power in the next section.