III - 15
Operation
3.10.7 After emptying
• Switch off the scraper floor.
• Switch off power take-off shaft
• Close the rear flap.
When the rear flap is closed, the metering
rollers are automatically switched off.
After passing over the silo,
• lower the articulated tow-bar again.
• Only run scraper floor reverse motion for a short time in order not to overload the scraper
floor.
Scraper Floor Reverse
If the metering rollers get stuck, switch on scraper floor
reverse motion.
• Select Scraper floor
Press Reverse
3.10.6 Stop Emptying
• Switch off scraper floor.
• Switch off power take-off shaft.
To Next Page
Loading...