VI - 11
Maintenance
6.10.2 Distance scraper to drum
The scrapers (2) must be at a distance „A“ from the
rotating conveyor drum (3).
Adjusting the distance from the cutter to the drum
• Slacken all screws (1) on the scraper bar on the right
and left.
• Twist the whole scraper bar until the distance A = 3-5
mm.
• Tighten the screws
KLW0911
1
KLW0A-08
6.11 Checking the safety rollers of
the single cutter safety system
The safety rollers (1) on the single cutter safety system
levers must turn easily while engaging (tensioning the
safety springs using the multi purpose key after the cutter
installation). If this is not the case turning will require
increased force. The single cutter safety system will not
operate correctly (increased cutter breakage). The rollers
(1) must therefore be removed, cleaned and reinstalled
with water-resistant EP long term grease (Part no. 926
045-0)
The circumferential grooves in the bolt (2)
must be completely filled with lubricant.
2
XXL00005
1
At the end of the season stop plate (1) must be checked
for wear.
If the thickness of the stop plate (t=6mm)
should be reduced by 50%, the plate must
be replaced (PN 334 975-2).
To Next Page
Loading...