Krone Big Pack 890 - Distributor Gearbox; Upper and Lower Pick-Up Gearbox

IX- 7
Care and Maintenance
9.4.4 Distributor Gearbox
The distributor gearbox (2) is located on the left side of
the machine.
Checking the oil level
Check the oil level in the distributor gearbox (2) each
time before using the machine. To do this, screw out the
control screw (1). The oil level must reach up to the
control drill hole. If necessary, top off the oil. After you
have checked, screw in the control screw again.
Changing the oil
Replace the oil after every season. To do this, remove
the control screw (1) and the oil drain screw (3). Capture
the oil in a suitable container as it drains out. Screw in
the oil drain screw again and refill with fresh oil up to the
control drill hole. Screw in the control screw again.
BP380-7-080
1
2
3
9.4.5 Upper and Lower Pick-up Gearbox
The upper and lower pick-up gearboxes (3) are located
on the right side of the machine.
Checking the oil level
Check the oil level in the pick-up gearbox (3) each time
before using the machine. To do this, screw out the
control screw (1). The oil level must reach up to the
control drill hole (1). If necessary, top off the oil. After
you have checked, screw in the control screw again.
Changing the oil
Replace the oil after every season. To do this, unscrew
the control screw (1) of the upper gearbox as well as the
venting screw (4) and drain screw (2) for the gears.
Capture the oil in a suitable container as it drains out.
Screw in the drain screw again.
Screw in the control and venting screw again.
4
1
2
BP000036
1
2
4
3
3