Maintenance
281
17.8 Checking and setting the axial play of the brake disc at the wrapping material brake
Fig.
Among other settings, the axial play of the brake disc (4) at the wrapping material brake must
be adjusted before setting the sensor B02 "Tying cycle active".
The axial play must be X=0.5–1.5 mm.
• To release the wrapping material brake, press the lever (5) down.
• Measure the axial play X of the brake disc (4) to the adjusting collar (1).
If the axial play is not X=0.5–1.5 mm:
• Raise the lever (6).
• Swivel the brake disc (4) with the roll holder (3) forward and pull off the brake disc (4).
• Remove the threaded pin (2) from the adjusting collar (1).
• By means of shim rings, adjust the desired axial play X.
• Mount the threaded pin (2) in the adjusting collar (1).
• Push the brake disc (4) on the roll holder (3) and swivel it back into the machine.
To Next Page
Loading...
