Krone KR 160 B - Net and Foil Wrapping Mechanism; Special Notes on Safety; Wrapping Material (Net); Inserting the Net (Foil) in the Wrapping Mechanism

87
12.4 Net and Foil Wrapping
Mechanism
12.4.1 Special Notes on Safety
• Before inserting the wrapping material (net or foil) in the round baler, switch off the PTO
shaft and allow the machine to come to a standstill.
• Switch off the engine. Remove the ignition key.
• Make sure, particularly for round balers with confort controls, that no undesired wrapping
cycles are started (see special equipment chapter "Electronic Comfort Controls").
• Always observe the special notes on safety listed in each chapter.
12.4.3 Inserting the Net (Foil) in the Wrapping Mechanism
To receive the roll of net there is a receiver mechanism
for the roll of net (3) located beneath the twine box.
Raise lever (2) to unlock the receiver mechanism.
Remove the brake disk (1). Make sure that the
cardboard sleeve on the roll of net is slid all the way up
the the roll holder (4).
Always raise the blade carrier to the upper position before inserting the net in the wrapping
mechanism and secure by inserting the locking pawl (right hand side of the machine behind the
drive wheel in the net wrapping mechanism). Great risk of injury!
12.4.2 Wrapping Material (Net)
The specifications in the chapter 1.2 "Technical Data"
must be met for the selection of the wrapping material
(net).
A high-quality wrapping material
guarantees problem-free execution of the
wrapping process and safe handling
during transport or further use of the
round bale. We recommend using the
wrapping material supplied by ourselves.
KR-0-013
2
4
3
Attention!- Contamination of tying twine as well as the tying mechanism by oil and grease
Effect: Damages to the machine and problems with unrolling of the tying twine
• Twine, twine tensioner and eyes must not be contaminated with oil or grease.
• Those parts of the tying device the tying twine or net will rum through, must not be
contaminated with oil or grease.