7
21.Only switch on equipment when all protective devices
are fitted and in protection position!
22.Persons are not allowed to enter the working area!
23.Keep clear of the area of rotation and swing of the
equipment!
24.Hydraulic controls must only be operated if no persons
are in the swing area!
25.Power operated parts (e.g. by hydraulics) contain danger
points which can cause injury by bruising and,
grazing!
26.Make sure that no personnel go between the tractor and
the implement unless the tractor is protected from rolling
by the parking brake and/or wheel blocks!
Trailed implements
1. Secure the implement against unintentional move-
ments.
2. Do not exceed the maximum load permissible on the
3-point linkage, drawbar or hitch.
3. In the case of trailed implements sufficient freedom
of motion must be provided at the hitch point.
6. Always ensure correct assembly and guarding of the
P.T.O. shaft!
7. Protect the P.T.O. shaft guard from rotating with the
shaft by fitting the chains!
8. Before switching on the power take-off shaft, make sure
that the p.t.o. speed of the tractor matches the permitted
speed of the implement!
9. When using the travel PTO shaft, take into account that
the shaft speed is dependent upon the speed of travel
and the direction of rotation is reveresed when the
tractor reverses.
10.Before switching on the power take-off shaft, make sure
that nobody is in the danger area of the implement!
11.Never switch on the power take off shaft when the tractor
engine is turned off!
12.Any work on the power take-off shaft may only be carried
out when nobody is in the area of the rotating power take-
off shaft or P.T.O. shaft.
13.The power take-off shaft should always be turned off
when the angle is too great or the p.t.o. shaft is not
required!
14.Danger! Working elements continue to rotate after the
power take-off shaft is turned off! Do not approach the
machine during this time! Work may only be carried out
on the machine when the machine is fully stationary and
the rotating parts have been secured by the parking
brake.
15.Cleaning, lubrication or adjustment of the P.T.O. shaft
or any equipment driven by the power take-off shaft may
only be carried out when the P.T.O. shaft and the engine
are turned off and the ignition key has been removed!
Rotating parts must be secured with the parking brake.
16.Place the detached P.T.O. shaft on the support bracket
provided!
17.After removing the P.T.O. shaft, place the protective
cover on the stub of the power take-off shaft!
18.Any damage must be repaired immediately before any
work is carried out with the attachment!
Power take-off shaft operation
1. Only the P.T.O. shafts prescribed by the manufacturer
may be used!
2. Both male and female guard tubes and cones of all
P.T.O. shafts must be fitted and in good condition!
3. Observe the tube overlap prescribed for P.T.O. shafts in
transport and operating position!
4. Before installing or removing the P.T.O. shafts, make
sure to turn off the power take-off shaft and the engine,
and remove the ignition key!
5. When using P.T.O. shafts with overload or free wheel
clutches that are not covered by the guards on the
tractor, the overload or free wheel clutches must be fixed
on the implement side!
To Next Page