22
2. Safety precautions / 3. Unpacking and assembly
• Do not cover ventilation slots.
• Do not insert any objects into ventilation slots.
• No humidity may intrude into the device.
• During analysing the melting point, the measuring head heats up extremely around
the ventilation slots. Do not touch the measuring head in this area.
• Only use suitable capillary tubes with an external diameter of 1.4 mm for the
determination of the melting point.
• When working with chemicals, follow safety precautions.
• When maintaining the device, e.g. changing the fuse, cleaning with a dry or any
slightly wet towel, always make sure that the device is disconnected from electricity.
• Only authorized personnel or the manufacturer may carry out servicing and
maintenance.
• Carefully unpack the device.
• Immediately report any transport damage occurred.
Find a suitable place for the device, i.e. avoid direct sunlight and vicinity of heating
devices. Connect power plug to 230 V / 50 Hz alternating current.
Before initial measuring the device should be switched on for about 15 min to reach
ideal working temperature.
2. Safety precautions
3. Unpacking and assembly
To Next Page
Loading...
