28
7. Starting the melting point analysis
The last melting point determined will be saved until the
device is turned off or a new melting point analysis is
started.
7.2 Express heating-up
After selecting the starting temperature, express heating
up will automatically be started after pressing the start
key. The current oven temperature will be displayed.
After reaching the selected starting temperature (the
device decreases heating-up speed approx. 3 °C before)
a signal tone will be heard for about 5 seconds.
Express heating up can be cancelled by pressing one of
the arrow keys. The selection of the target temperature
(see chapter 6.2) is started with the arrow keys. The fan
will not be activated! The printing key has no function.
express heating
Temp. 78.8 °C
7.3 Slow heating-up
Slow heating-up means approx. 1 °C per minute.
The process is automatically started by inserting a filled
capillary tube when the selected starting temperature
has been reached. The melting process is displayed
in °C and % from the beginning of melting until the
melting-point is reached. The current target temperature
of the melting-oven is displayed.
In case the melting point is not reached within 30 min,
the slow heating-up process will be interrupted by time-
out and and an internal error value will be saved as
melting point.
By pressing the arrow keys, the process can be inter-
rupted at any time. The device will then jump to menu
item 6.2 selection of target temperature. No fan will be
activated! The printing key has no function.
1°C/min 2 %
Temp.121.3 °C
To Next Page
Loading...
Need help?
General
