Remote Lever Cable Housing
Your new LEV seatpost includes a 1700mm long cable, 1500mm
long cable housing, and an in-line barrel adjuster. Depending on
your own requirements, you may need to shorten the cable to
minimize excess slack when mounted to your frame.
With the remote lever installed on your handlebar, route the cable
housing according to your frame manufacturer’s
recommendations. You will need to cut the housing into two
pieces to fit the in-line barrel adjuster. The total length of the two
pieces of housing and barrel adjuster must be long enough to
properly route from the remote lever to the seatpost.
Feed the inner wire through the remote lever, integrated barrel
adjuster and cable housing.
To Next Page
Loading...
