WKT
3
Introduction
KSB has supplied you an equipment that has been designed and manufactured with the latest technology.
Due to its simple and tough construction, it will need few maintenance. With the aim to provide our clients with a
satisfactory, trouble free operation, we recommend to install and care our equipment according to the instructions
contained in this service manual.
This manual has been prepared to inform the end user about construction and operation of our pumps, describing the
proper procedures for handling and maintenance.
We recommend that this manual should be handled by the maintenance supervision.
This equipment must be used at operation conditions for which it has been selected, such as: flow rate, total head, speed,
voltage, frequency and temperature of pumped liquid.
Fig. 01 - Nameplate
For requests about the equipment, or when ordering spare parts, please mention the type of the pump and
the Production Order number (serial nº). This information can be obtained from the nameplate of each
pump. If the nameplate is not available, the OP number is engraved in low relief on the suction flange and
on the discharge flange you may find the impeller diameter.
Attention: This manual contains very important recommendations and instructions. Must be carefully read before
installation, electrical connection, first start up and maintenance.
Place for description
of type and size of
the
um
Place for order
number
To Next Page
Loading...
