WKT
4
1. General
This KSB product has been developed
in accordance with state-of-the-art
technology; it is manufactured with utmost care and
subject to continuous quality control.
These operating instructions are intended to facilitate
familiarization with the unit and its designated use.
The manual contains important information for reliable,
proper and efficient operation. Compliance with the
operating instructions is of vital importance to ensure
reliability and a long service life of the unit and to avoid
any risks.
These operating instructions do not take into account
local regulations; the operator must ensure that such
regulations are strictly observed by all, including the
personnel called in for installation.
This pump / unit must not be operated beyond
the limit values for the fluid handled, capacity,
speed, density, pressure, temperature and motor
rating specified in the technical documentation. Make
sure that operation is in accordance with the instructions
laid down in this manual or in the contract
documentation. Contact the manufacturer, if required.
The nameplate indicates the type series / size, main
operating data and works number; please quote this
information in all queries, repeat orders and particularly
when ordering spare parts.
If you need any additional information or instructions
exceeding the scope of this manual or in case of damage
please contact KSB´s nearest customer service centre.
For noise characteristics please refer to section 4.3.6.
2. Safety
These operating instructions contain fundamental
information which must be complied with during
installation, operation, monitoring and maintenance.
Therefore this operating manual must be read and
understood both by the installing personnel and the
responsible trained personnel / operators prior to
installation and commissioning, and it must always be
kept close to the location of operation of the machine /
unit for easy access.
Not only must the general safety instructions laid down in
this chapter on “Safety” be complied with, but also the
safety instructions outlined under specific headings,
particularly if the pump / unit is operated in hazardous
areas (see section 2.9).
2.1 Marking of instructions in the manual
The safety instructions contained in this manual whose
non-observance might cause hazards to persons are
specially marked with the symbol
general hazard sign to ISO 7000-0434
the electrical danger warning sign is
safety sign to IEC 417-5036
and special instructions concerning explosion protection
are marked
The word
is used to introduce safety instructions whose non-
observance may lead to damage to the machine and its
functions.
Instructions attached directly to the machine, e.g.
- arrow indicating the direction of rotation
- markings for fluid connections
must always be complied with and be kept in a perfectly
legible condition at all times.
2.2 Personnel qualification and training
All personnel involved in the operation, maintenance,
inspection and installation of the unit must be fully
qualified to carry out the work involved.
Personnel responsibilities, competence and supervision
must be clearly defined by the operator. If the personnel
in question is not already in possession of the requisite
know-how, appropriate training and instruction must be
provided. If required, the operator may commission the
manufacturer / supplier to take care of such training. In
addition, the operator is responsible for ensuring that the
contents of the operating instructions are fully understood
by the responsible personnel.
2.3 Non-compliance with safety instructions
Non-compliance with safety instructions can jeopardize
the safety of personnel, the environment and the machine
/ unit itself. Non-compliance with these safety instructions
will also lead to forfeiture of any and all rights to claims for
damages.
In particular, non-compliance can, for example, result in:
- failure of important machine / system functions;
- failure of prescribed maintenance and servicing
practices;
- hazard to persons by electrical, mechanical and
chemical effects as well as explosion;
- hazard to the environment due to leakage of
hazardous substances.
2.4 Safety awareness
It is imperative to comply with the safety instructions
contained in this manual, the relevant national and
international explosion protection regulations, and the
operator´s own internal work, operation and safety
regulations.
Ex symbol relates to additional requirements
which must be adhered to when the pump is
operated in hazardous areas.
Caution
Caution
To Next Page
Loading...
