7.7.6 Final assembly and installation
If the pump body had to be replaced, install the pump in the can:
1. Standard installation depth: (
⇨ Section 5.5.1 Page 28)
2. Large installation depth: (⇨ Section 5.5.2 Page 29)
3. Mounting the motor: (⇨ Section 5.6 Page 31)
7.7.7 Fitting the protective equipment
WARNING
Failure to re-install or re-activate protective devices
Risk of injury from moving parts or escaping fluid!
▷ As soon as the work is completed, re-install and/or re-activate any safety-
relevant and protective devices.
WARNING
Distributor casing and bearing housing take on the same temperature as the fluid
handled.
Risk of burns!
▷ Insulate the distributor casing.
▷ Fit protective equipment.
CAUTION
Heat build-up in the bearing housing
Damage to the bearing!
▷ Never insulate the bearing housing and bearing cover.
1. Fit all protective equipment, such as guards, monitoring devices, etc.
7.8 Spare parts stock
7.8.1 Ordering spare parts
Always quote the following data when ordering replacement or spare parts:
▪ Type series
▪ Material variant
▪ Size
▪ Seal code
▪ KSB order number
▪ Order item number
▪ Consecutive number
▪ Year of construction
Refer to the name plate for all data.
Also specify the following data:
▪ Description
▪ Part No.
▪ Quantity of spare parts
▪ Shipping address
▪ Mode of dispatch (freight, mail, express freight, air freight)
Refer to the exploded view or general assembly drawing for part numbers and
descriptions.
7 Servicing/Maintenance
WKTR
63 of 78
To Next Page
Loading...
