-40-
4.7 Loopback Test
This menu is used to start a loopback test operation with the link partner unit over the fiber link. The
message displayed during test is:
The result message displayed after a test finished is:
The test result is also displayed on LEDs - LBT and LBR.
4.8 Reboot System
This menu is used to reboot the device unit remotely with current configuration. Starting this menu will
make your current http connection lost. You must rebuild the connection to perform any management
operation to the unit.
4.9 Restore Default
This menu is used to restore all settings of the device unit with factory default values except current IP
configuration and Management VLAN configuration.
To Next Page
Loading...
Need help?
General