IMPORTANT NOTES 9
Some of the spare parts and accessory products are specified in parentheses under the respective descriptions. Your KTM dealer will be
glad to advise you.
You will find the current KTM PowerParts for your vehicle on the KTM website.
International KTM Website: http://www.ktm.com
Work rules
Special tools are necessary for some of the work. These are not included with the vehicle and can be ordered under the number in paren-
theses. Ex: valve spring mounter (59029019000)
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, O-rings, pins, lock washers) must be replaced
by new parts.
If thread lock (e.g. Loctite
®
) is used for screw connections, be sure to comply with the manufacturer's specific instructions on its usage.
Parts that you want to reuse following repairs and servicing should be cleaned and checked for damage and wear. Change damaged or
worn parts.
Following repairs or servicing, the vehicle must be checked for roadworthiness.
Transport
Note
Danger of damage The parked vehicle can roll away or fall over.
– Always place the vehicle on a firm and even surface.
Note
Fire hazard Some vehicle components get very hot when the machine is driven.
– Do not place the vehicle where there are flammable or explosive substances. Do not place objects over the vehicle while it is still warm
from being run. Always let the vehicle cool first.
– Switch off the engine and remove the ignition key.
– Secure the motorcycle against falling over or running away using straps or other suitable devices.
To Next Page
Loading...
Need help?
General
