SERVICE WORK ON THE ENGINE 89
101221-10
– Pull oil filter out of the oil filter housing.
Circlip pliers reverse (51012011000)
– Completely drain the engine oil.
– Clean the parts and the sealing area thoroughly.
16.5Installing the oil filter x
101222-10
– Insert oil filter .
– Lubricate the O-ring of the oil filter cover. Mount oil filter cover .
– Mount and tighten the screws.
Guideline
Remaining engine screws M5 6 Nm (4.4 lbf ft)
16.6Filling up with engine oil x
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
101216-10
– The oil must be added in two steps.
Engine oil 3.60 l (3.8 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 118)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 118)
– Remove screw and add engine oil.
Engine oil (1st
quantity)
3.00 l (3.17 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 118)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 118)
– Mount screw .
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
– Start the engine and check that it is oil-tight.
– Remove screw and pour in the remaining engine oil.
Engine oil (2nd
quantity)
0.60 l (0.63 qt.) External tem-
perature: ≥ 0 °C
(≥ 32 °F)
Engine oil
(SAE 10W/50)
( p. 118)
External tem-
perature: < 0 °C
(< 32 °F)
Engine oil
(SAE 5W/40)
( p. 118)
To Next Page
Loading...
