11 SERVICE WORK ON THE CHASSIS 59
B02108-01
(All XC models)
– Check the routing of the throttle cable.
The throttle cable must be routed along the back of the handlebar, to the
right of the frame, below the fuel tank bracket, and to the carburetor.
» If the throttle cable is not routed as specified:
– Correct the routing of the throttle cable.
Finishing work
–
Install the fuel tank. x ( p. 53)
– Mount the seat. ( p. 48)
11.42 Checking the rubber grip
401197-01
– Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
» If a rubber grip is damaged, worn, or loose:
– Change and secure the rubber grip.
Rubber grip adhesive (00062030051) ( p. 121)
11.43 Additionally securing the rubber grip
Preparatory work
– Check the rubber grip. ( p. 59)
401198-01
Main work
– Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rub-
ber grip.
11.44 Adjusting the basic position of the clutch lever
101698-10
(125/150 SX)
– Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw
.
To Next Page
Loading...
