KTM 1290 Super Duke R 2017 User Manual

10 RIDING INSTRUCTIONS 93
– Make sure that the emergency OFF switch/electric starter button is in the middle posi-
tion .
– Switch on ignition; to do this, briefly press the Race-on button (maximum of 1 sec-
ond).
The steering is unlocked.
The function check of the combination instrument is run.
The ABS indicator lamp goes out when you start off.
Info
If the handlebar does not unlock, move the handlebar slightly.
– Shift the transmission to idle .
The green idling speed indicator lamp lights up.
E00712-10
– Turn the emergency OFF switch/electric starter button to the lower position .
Info
Do not press the emergency off switch/electric starter button into the lower posi-
tion until the combination instrument function check has been completed.
When starting, DO NOT open the throttle. If you open the throttle during the start-
ing procedure, fuel is not injected by the engine management system and the
engine cannot start.
Press the emergency OFF switch/electric starter button into the lower position
for a maximum of 5 seconds. Wait for a least 5 seconds before trying again.
This motorcycle is equipped with a safety starting system. You can only start
the engine if the transmission is in neutral or if the clutch lever is pulled when
a gear is engaged. If the side stand is folded out and you shift into gear, the
engine stops.

KTM 1290 Super Duke R 2017 Specifications

General

Displacement	1301 cc
Bore x Stroke	108 mm x 71 mm
Fuel System	Keihin EFI, 56 mm throttle bodies
Transmission	6-speed
Rear Suspension	WP monoshock
ABS	Bosch 9ME Combined ABS
Front Tire	120/70 ZR 17
Rear Tire	190/55 ZR 17
Seat Height	835 mm
Dry Weight	195 kg
Power	177 hp
Torque	141 Nm
Frame	Chromium-Molybdenum steel trellis frame
Front Suspension	WP Ø 48 mm
Front Brake	Dual 320 mm discs, Brembo 4-piston calipers
Rear Brake	Brembo two-piston caliper, 240 mm disc
Wheelbase	1482 mm
Fuel Tank Capacity	18 liters