WHEELS, TIRES 15
251
S03926-11
– Position brake calipers and check that the brake linings are
seated correctly.
–
Mount screws
5
on both brake calipers but do not tighten
yet.
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake calipers straighten.
–
Tighten screws
5
on both brake calipers.
Guideline
Screw, front
brake caliper
M10 45 Nm (33.2 lbf ft)
Loctite
®
243™
– Remove the locking piece of the hand brake lever.
– Take the motorcycle off the front lifting gear. ( p. 201)
– Remove the rear of the motorcycle from the lifting gear.
( p. 199)
To Next Page
Loading...
