ELECTRICAL SYSTEM 16
267
S03934-10
Main work
–
Remove control unit
1
and hang to the side.
–
Disconnect negative cable
2
of the 12-V battery to avoid
damaging the onboard electronics.
–
Remove positive terminal cover
3
.
602678-01
– Connect the battery charger to the 12-V battery. Switch on the
battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the open-circuit
voltage and starting ability of the 12-V battery, and to test the
alternator. In addition, you cannot overcharge the 12-V battery
with this device.
Info
Charge the 12-V battery to a maximum of 10 % of the
capacity specified on the battery housing.
– Switch off the battery charger after charging and disconnect
from the 12-V battery.
To Next Page
Loading...
