16 ELECTRICAL SYSTEM
276
M01489-10
– Remove the screw on the front of the turn signal housing.
–
Carefully remove turn signal glass
1
.
–
Press bulb
2
carefully into the socket, turn it counterclock-
wise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
– Push the new bulb gently into the socket and turn it clockwise
all the way in.
Turn signal (RY10W / socket BAU15s) ( p. 323)
– Check that the turn signal is functioning properly.
– Position the turn signal glass.
Info
Insert holding lug
A
into cut-out
B
.
– Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
To Next Page
Loading...
