Oil pump, reed valve housing and intake flange (separate
lubrication)
– Insert the reed valve housing into the engine case, and position the
intake flange such that the bolt
1 can be mounted. Mount the bolt,
but only tighten it such that it is still possible to rotate the intake
flange.
– Insert the oil pump with a new gasket into the engine case, and fix it
with the 2 bolts
2.
– Mount the oil pump housing. When mounting, be careful not to kink
the two hoses .
– Mount the 2 dowel bushings
3.
– Slide the oil-pump wheel
4 onto the oil pump.
–Mount the clutch cover
5 and tighten the bolts including 6. To
tighten the two bolts
7 it is necessary to hold the oil pump cover 8
in position.
– Mount the remaining 4 bolts of the intake flange, and tighten each of
the 5 bolts.
6-7C
3
2
1
4
6
7
5
8
To Next Page
Loading...
