16 COOLING SYSTEM 146
L02265-10
–
Release bleeder screw
by three turns.
– Tilt the vehicle slightly to the right.
– Pour in coolant until it emerges without bubbles at the bleeder screw, and then mount
and tighten the bleeder screw immediately.
Coolant ( p. 184)
– Fill the radiator completely with coolant. Mount the radiator cap.
– Rest the vehicle on the side stand.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
– Start the engine and let it run warm.
M00464-11
– Stop the engine and allow it to cool down.
– When the engine is cool, check the coolant level in the radiator and, if necessary, add
coolant.
–
Remove the cap of the compensating tank
and add coolant until the coolant level is
up to the MAX mark.
– Mount the cap of the compensating tank.
Finishing work
– Fit the front spoiler. ( p. 95)
– Install the left side cover. ( p. 98)
To Next Page
Loading...
Need help?
General
