SERVICE SCHEDULE 45
S1N S10A S20A
Check the parking brake. x
• • •
Lubricate all moving parts (e. g. hand levers, chain, ...) and check for smooth operation. x
• •
Check the fluid level of the hydraulic clutch. ( p. 102) • •
Check the front brake fluid level. ( p. 107) • •
Check the free travel of the hand brake lever. ( p. 105) • •
Check the bearing clearance of the steering column. • • •
Check the bearing of the handlebar bridge. x
• •
Check the valve clearance. x
• •
Check the clutch. x
• •
Check all hoses (e. g. fuel, cooling, bleeding, drainage) and sleeves for tearing, leaks, and incorrect rout-
ing. x
• • •
Check the antifreeze and coolant level. ( p. 137) • • •
Check cables for damage and routing without sharp bends. x
• •
Check the cables for damage, routing without sharp bends, and correct adjustment. • • •
Clean the air filter and air filter box. x
• •
Change glass fiber yarn filling of main silencer. x
• •
Check the screws and nuts for tightness. x
• • •
Check the idle. x
• • •
Check that the radiator fan is functioning properly. x
• • •
Final inspection: check the vehicle for operating safety and take a test ride. • • •
Create a service entry in the KTM DEALER.NET and in the service record. x
• • •
S1N: Once after 1 operating hour - corresponds to about 7 liters of fuel (1.8 US gal)
S10A: Every 10 operating hours - corresponds to about 70 liters of fuel (18.5 US gal) / after every race
S20A: Every 20 operating hours - corresponds to about 140 liters of fuel (37 US gal)
To Next Page
Loading...
