Main fuse
The main fuse protects all power-consuming units on the motorcycle. It is located under the
tank on the starter relay.
Remove the seat and move the tank back as described in the "Battery" section.
After removing the cap [1], the main fuse [2] can be pulled out with long-nose pliers. It has
a capacity of 30 amperes. A spare fuse [3] is located on the starter relay. If a new fuse that
has just been set in gets blown again, you are strongly advised to have it inspected by a KTM
dealer. The fuse capacity is 30 Ampere.
– Under no circumstances is a stronger fuse allowed to be set in or a fuse allowed to be
„repaired“. An inexpert treatment could damage the whole electrical installation!
– Contact a specialized KTM dealer, should defects of the electric system occur more
frequently.
Mount the tank and seat.
Set the clock.
Jump start
Jump starts are not recommended since they can damage the motorcycle's electronic
system.
MAINTENANCE WORK ON CHASSIS AND ENGINE »
54
To Next Page
Loading...
