Remove the oil filter cover [5] and pull the oil filter out of the engine case with circlip
pliers (upside-down).
Remove the plug with the oil screen [6].
Thoroughly clean the plugs, cover and both oil screens. Clean all rubber seal rings and check
for damage; replace if necessary. Clean the sealing areas on the engine case.
Insert the oil screen [6] in the engine case as illustrated, mount the plug and tighten to
15 Nm.
Use the same procedure to mount the oil screen on the right side of the engine.
MAINTENANCE WORK ON CHASSIS AND ENGINE »
67
To Next Page
Loading...
