ELECTRICAL SYSTEM 16
89
Preparatory work
– Remove the passenger seat. ( p. 63)
V01203-11
Main work
–
Disconnect negative cable
1
from the 12 V battery to avoid
damaging the onboard electronics.
–
Remove positive terminal cover
2
.
602678-01
– Connect a battery charger to the 12-V battery. Switch on the
battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the open-circuit
voltage and starting ability of the 12-V battery, and to test the
alternator. In addition, you cannot overcharge the 12-V battery
with this device.
Info
Charge the 12-V battery to a maximum of 10 % of the
capacity specified on the battery housing.
– Switch off the battery charger after charging and disconnect
from the 12-V battery.
Guideline
The charging current, charging voltage, and charging time
must not be exceeded.
Recharge the 12-V battery
regularly when the motorcy-
cle is not being used
3 months
V01203-11
–
Mount positive terminal cover
2
.
–
Connect negative cable
1
to the 12 V battery.
Finishing work
– Mount the passenger seat. ( p. 63)
– Set time and date.
To Next Page
Loading...
