KTM 85 SX 2004 - DISMOUNTING OF THE CRANKSHAFT

Repair manual KTM 85 SX Art No 3.206.008-E
4-8
–Take the pressure springs 1 out of the engine case.
– Pull the drive shaft together with the countershaft out of the bearing
seats.
– Remove 1
st
-gear idler gear 2 with needle cage and the two stop
discs from the engine case.
Dismounting the crankshaft
– Pull crankshaft from the bearing seat (if necessary, use a plastic
hammer and tap carefully on the crankshaft journal).
– Clean all parts and check for wear, replace if necessary.
NOTE: When an engine is completely overhauled it is recommended
that all gaskets, shaft seal rings and O-rings are renewed.
1
1
2