KTM F8201W5 - Handlebar Position; Adjusting the Handlebar Position

10 TUNING THE CHASSIS
46
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
10.16 Handlebar position
F03636-10
The holes on the handlebar support
1
are placed at a distance
of
A
from the center.
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Info
In addition, the handlebar can be mounted rigidly or on a
rubber bearing.
10.17 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
– Change the handlebar if the handlebar is damaged or bent.
Info
The handlebar can be mounted rigidly or on a rubber bearing.
Preparatory work
– Take off the handlebar cushion.