Kubota 05 Series Repair Manual

DIESEL ENGINE
05 SERIES WSM, 01640
0
-
DOOF10130 -
OOOOOFI 01 50
2:OK ,oo,oo
-lr-nmf-
OOOOOFI 0160
Valve Spring Setting Load
1. Place the valve spring on a tester and compress it to the same
2, Read the compression load on the gauge.
3. If the measurement is less than the allowable limit, replace it.
length it is actually compressed in the engine.
OOOOOS10092
Oil Clearance between Rocker Arm Shaft and Beraing
1. Measure the rocker arm bearing I.D. with an inside micrometer.
2. Measure the rocker arm shaft O.D. with an outside micrometer,
and then calculate the
oil clearance,
3. If the clearance exceeds the allowable limit, replace the rocker
arm and measure the oil clearance again. If
it still exceeds the
allowable limit, replace also the rocker arm shaft.
00000s10102
Push Rod Alignment
1. Check the both end of the push rod for cracks, damage and
2. Measure the bending of the push rod with a dial indicator.
3. If the measurement exceeds the allowable limit, replace the push
unusual wear.
rod.
00000s10111
Oil Clearance between Tappet and Tappet Guide Bore
1, Measure the tappet O.D. with an outside micrometer
2. Measure the I.D. of the tappet guide bore with a cylinder gauge,
3, If the oil clearance exceeds the allowable limit or the tappet is
and calculate the oil clearance.
damaged, replace the tappet,
OOOOOS10122
5-113
Redistribution or publication of this document, 
by any means, is strictly prohibited.

Kubota 05 Series Specifications

General

Brand	Kubota
Model	05 Series
Category	Engine
Language	English