Mower conditioner
78
FC302RG - FC352RG
Maintenance and storage
KN271BGB C
4. Storage
At the end of each season
- Clean the machine thoroughly.
- Drain all gearboxes and cutterbar and refill with new
oil (see "Lubrication" chapter).
- Touch up any areas of damaged paintwork.
- Put the machine under cover in a dry place.
- Inspect and replace worn knives and bolts (See
section: Inspection of knives and securing elements).
- Inspect and replace worn or damaged fingers on the
conditioning rotor.
- Slacken V-belts and check their condition.
- Depressurize all hydraulic functions.
At the start of each season
- Pressurize the hydraulic circuit.
- Check the condition of the friction slip clutch (See
section: Intermediate PTO shaft).
- Inspect and replace worn knives and bolts (See
chapter: Inspection of knives and securing elements).
- Check that all nuts and bolts are sufficiently tightened.
- Re-read the operators' manual.
- Retension V-belts.
- Check belt guard condition and if it is firmly secured in
place.
- Inspect and replace worn or damaged fingers on the
conditioning rotor.
- Check tyre pressure.
- Make sure that all protection devices are in place and
in good condition.
To Next Page
Loading...
