Preparing for operation
18
Preparing for operation
This chapter will guide you through the preparations that must be
made on the plough and tractor before you start operating the plough.
Tractor
Hydraulic connections
The following chart shows the connections required on the tractor.
Depth control
We recommend that the tractor's depth control be initially set accord-
ing to the following table. The exact settings are determined by the soil
and field conditions.
Wheel distance
•
The tractor's inner wheel distance with which the plough can be
used is from 110-160 cm.
•
The distance between the front wheels must be 0 to 10 cm wider.
Hydraulic functions Single-acting Double-acting
Hydraulic control system 1
Hydraulic furrow width 1
Hydraulic depth wheel 1
Hydraulic first furrow width [+] 1
Plough size Depth control of the plough
Initial settings
Draft power regulated depth control
Position control <------------> Draft control
5 - 8 furrows |--X-------------------------------------------|
110 - 160 cm
0-10 cm wider than the rear
To Next Page