Now all you need to do is turn the system ON
and ensure everything works properly.
1. Ensure the antenna has a clear view of the
southern sky.
2. Apply power to the TV and the TracVision
system.
3. Turn on the power switch on the receiver’s
rear panel.
4. Wait while the antenna searches the sky for the
DIRECTV satellite. Once the antenna finds the
satellite, the receiver downloads the program
guide. A progress bar should display on your
TV. (It could take 60 seconds to load the program
guide, once it begins loading.)
If the system shuts off after 30 seconds, simply
press the “Antenna Power” button on the
receiver’s front panel.
5. Once a DIRECTV picture appears on the TV,
verify that the 3 status lights on top of the
receiver are lit green.
A - VOLTAGE Light
B - RECEIVER Light
C - ANTENNA Light
Refer to the Quick Start Guide and Receiver
User’s Guide for complete operation instructions
and troubleshooting information.
54-0274-01 Rev. A 11 © 2005 KVH Industries, Inc., All rights reserved.
Test the System
11
is prepared.
Acquiring guide data...
Only the DIRECTV preview channel
(channel 100) is viewable until the
owner activates the receiver.
Status Lights
A
B
C
Antenna Power
Button
Power Switch
To Next Page
Loading...
Need help?
General
