KYMCO CV3 Series - Outer Transmission Belt Inspection

3
Checks before Riding
100
6
Inspect the outer transmission belt
 Erect the vehicle with the main stand, rotate with rear
wheel manually, visually inspect whether the outer
belt has abnormal scuff marks.
 Whether there are foreign objects attached, and
remove them.
 Whether the belt and the pulley are rubbing on a
single side, and has no more gap.
 The screws of the top / bottom cover of the belt are
loose.
If the above problems cannot be resolved, please visit
the KYMCO service station for inspection or
replacement.
Caution
 Please do not adjust the belt and remove relevant
rear wheel mechanisms arbitrarily. They should be
repaired by professionals at the KYMCO service
station.
 If there are cracks or deformed damages to the
top/bottom covers, they should be repaired
immediately for safety.
Warning
 Please do not ride the vehicle with the top / bottom
belt covers removed.
 Do not insert any tools or bodily parts into the vehicle
when the engine is turned on or is moving.
 Do not spray or apply any oil or unknown solvents to
the belt to prevent the mutation of the material.
 The passenger shall not use the top cover as the
footrest. This may deform the cover and affect the
belt.