Proper Riding Method
81
Proper Riding Method
Keep the Rear Brake Lever in braking state and push
the vehicle forward, the Main Stand will spring up
automatically.
Mount the vehicle from the left side and then sit
squarely, with both feet touching the ground to
prevent tilting. Adjust the rear view mirror to the
intended position.
Release the front wheel anti-tilting lock device after
sitting properly with both feet on the ground for
support, and watch out for the change of center of
gravity from 3 wheels to 2 wheels after unlocking the
device.
Keep engine rpm away from the red zone.
After starting the engine, do not raise engine rpm while not
advancing the vehicle, or danger may occur.
Before advancing, keep the Rear Brake Lever in braking
state. DO NOT raise engine rpm arbitrarily.
The front wheel locking device will be automatically
released as the openness of the throttle reaches the
threshold; thus, the rider must be careful with such
dangerous actions.
The owner must practice the vehicle’s shift of center of
gravity between the unlocking/locking state of the locking
device. This is of utmost importance and is a matter of
personal safety.