Proper Riding Method
80
When not in use after stopping the vehicle, be sure to
set the main switch key to the “OFF” position to prevent
the battery from discharging excessively.
5. Hold the front brake lever or the rear brake lever,
and then press the “Electric Start” button and the
engine will become active.
6. If starting is difficult, release the Start Button and
wait for a few seconds before trying again. Each re-
try shall not exceed 5 seconds, for preserving battery
power.
Keep finger off from Start Button immediately when
engine starts.
Never push the start button when engine is running,
or engine parts may get damage.
When starting the engine, the rear brake lever shall
be set to braking state, the brake light shall light up
when the power is connected.
Allow a brief warm-up after starting a cold engine
(about 1-2 minutes), in mountains and cold areas,
prolong the warm-up (about 3-5 minutes), for
facilitating engine operation and a trouble-less riding.
Before advancing, keep the Rear Brake Lever in braking
state. DO NOT raise engine rpm arbitrarily.
To Next Page
Loading...
Need help?
General
