Control Functions of Mechanism
49
Left Handlebar Switch
1. Cruise setting key
2. High/Low Beam Switch
3. Winker Switch
4. Reset/Adjust key
5. Set/Adjust key
6. Horn Switch
7. Handlebar Heater Indicator
Cruise control setting button:
The vehicle speed must be greater than 45km/h to set
the setting.
The steps are as follows:
1. Press cruise control button ON
2. Start the setting after the indicator is lighted.
3. Accelerate to the desired cruise range.
4. Press "SET" key.
5. Execute the cruise function
After setting the desired speed, adjust the
acceleration and deceleration between 45-130
km/hour (adjusted by 2km/hour each time).
Condition to cancel cruise control: 1. Pull the brake
2. Press the cruise control button.
RES function: Press this button if the rider wishes to
resume the previous speed setting after cruise
control is cancelled.
To release the cruise with brake, press “RES” again
and you may return to the speed set last time. If you
need to release the cruise with the “OFF” key, then
set the cruise once again.
To Next Page
Loading...
Need help?
General
