Simplified Maintenance and Repair
112
User Precautions:
1. Do not remove battery cable when KEYLESS Main
Switch is set to ON.
2. Tighten torque: 0.1~0.2 kgf-m (do not exceed 0.6
kgf-m). Tighten bolts using a maintenance tool; do
not tighten it excessively or the bolt may break and
cable may get loose, resulting in an accident.
3. After installation, make sure that bolts will not
slacken and wires will not interfere with chassis, so
as to prevent any potential danger.
4. When the user or personnel of service station
removes the muffler, it is necessary to disconnect
O2 sensor connector first.
When riding or parking vehicle in humid environments
(e.g. in a rainy day or washing vehicle), fog formation
may occur temporarily inside the cover of Dashboard
and lights due to inside/outside temperature differences;
which is not a quality issue of them. However if large
amount of drops or accumulation of water appears
inside Dashboard and light cover, please consult a
KYMCO dealer for receiving service.
To Next Page
Loading...
Need help?
General
