COMMAND CENTER Pages
Operation Guide 13
Basic > Security > Device Security > Network Security
This allows you to enable communication with the printing system on a per-protocol
basis.
Basic > Security > User Login
When the authentication function is set on the Advanced > Management >
Authentication page, you must register users and set access levels on this page.The
available access levels are User and Administrator.
One administrator account is registered by default.
Adding a New User Login
1. Open the User Login page.
2. Click Add and enter the information of the user.
3. Click Submit.
Editing a User Login
1. Open the User Login page.
2. Click the desired Login User Name or Name to edit the user and modify their
information.
3. Click Submit.
Deleting a User Login
1. Open the User Login page.
2. Check the desired user. When the checkbox on the left side of Login User Name is
selected, all users displayed on the page will be checked.
3. Click Delete.
The User Login - Delete page appears. You can confirm the users to be deleted.
4. Click Delete when the desired users are selected.
Item Description
SNMP v3,
NetWare,
AppleTalk,
NetBEUI, Raw,
IPP, IPP over
SSL, HTTP,
HTTPS, FTP,
SNMP, SMTP,
POP3, LPD,
WSD Print
Specifies whether or not to restrict communication via each
of the protocols on the left.
The communication via the protocols that are set to Lock is
restricted.
The settings made on this page affect the protocol settings
on the Advanced page.
To Next Page
Loading...
Need help?
General