Kyocera DP-1800 - LDFC - Load Font Character

LDFC
147
LDFC — LoaD Font Character
Format
LDFC font-number, code, height, width, y-offset, x-offset,
cell-width, center, rotation[, resolution]; bit-map;
Parameters
font-number:
font number (integer from 1000 to 65535). Same for all characters in the font. Must not
duplicate any resident bitmap font number.
code:
ASCII code of the character (0 to 255)
height:
height of the character bitmap, in dots (integer from 0 to 3999)
width:
width of the character bitmap, in dots (integer from 0 to 3999)
y-offset:
distance from the baseline to the top of the character bitmap, in micro dots [
1
/
32
dot]
(integer from -32768 to 32767); positive – up, negative – down
x-offset:
distance from the left edge of the character cell to the left edge of the character bitmap, in
micro dots [
1
/
32
dot] (integer from -32768 to 32767); positive – up, negative – down
cell-width:
total width of the character cell, in micro dots [
1
/
32
dot] (integer from 0 to 65535). This
parameter is used in proportional spacing.
center:
distance from the left edge of the character cell to center of the character, in micro dots
[
1
/
32
dot] (integer from 0 to 65535)
rotation:
0 = portrait
1 = upside-down landscape
2 = upside-down portrait
3 = landscape
resolution:
resolution of the character, 300 [dpi], 600 [dpi], or 1200 [dpi]