Kyocera DP-1800 - XBCP 8 - Automatically Set Rows and Columns

PRESCRIBE Command Reference
374
XBCP 8 — automatically set rows and columns
Format
XBCP 8;
Parameter
None
Function
The XBCP 8 command permits the system to automatically set rows and columns so that
it satisfies the requirement that the multiplication of rows times columns is less than or
equal to 928. Default is disabled.
Note that the XBCP 8 overrides XBCP 4 and/or 5 which set the number of rows and
c
o
lumns. However, this command is not effective if both XBCP 6 and XBCP 4 and/or 5
are issued together. Precedence of XBCP modes is: 4/5<8, 4/5+8<6.