Operation on the Machine > WSD Scan
256
Executing WSD scan
WSD Scan saves images of originals scanned on this machine as files on a WSD-compatible computer.
NOTE
• When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
➡ Primary Network (Client) (page 495)
• To use WSD Scan, confirm that the computer used for WSD scanning and the machine are network-connected,
and "WSD Scan" is set to [On] in the network settings.
➡ WSD Scan (page 456)
• For information on operating the computer, refer to the computer's help or the operation guide of your
software.
1
[Home] key > [Send]
2
Place the original.
➡ Loading Originals (page 220)
3
In the destination screen for sending, select [Enter destination] > [WSD Scan]
4
Scan the originals.
• For procedure using this machine, refer to step 8 in step 5.
• For procedure from your computer, refer to step 10
in step 9.
5
(Procedure using this machine) [From Operation Panel] > [Next >]
6
Select the destination computer > [OK]
Select [Reload] to reload the computer list.
You can view information on the selected computer by selecting (information icon).
7
Set the type of original, file format, etc., as desired.
8
Press the [Start] key.
Sending begins and the software installed on the computer is activated.
9
(Procedure from your computer) [From Computer] > [Start]
10
Use the software installed on the computer to send the images.
To Next Page
Loading...
