Operation on the Machine > Using Document Boxes
285
Sending Documents in a Custom Box
NOTE
When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
➡ Primary Network (Client) (page 495)
1
Display the screen.
[Home] key > [Custom Box] > Select the box
NOTE
If the Custom Box is protected by a password, enter the correct password.
2
Send the document.
1 Select the document you wish to send by checking the checkbox.
The document is marked with a checkmark.
NOTE
• You cannot select and send multiple documents.
• To deselect, select the checkbox again and remove the checkmark.
2 Select [Send].
NOTE
Depending on the settings, the address book screen may appear.
3 Set the destination.
For more information on selecting destinations, refer to the following:
➡ Specifying Destination (page 264)
IMPORTANT
Only when specifying the E-mail addresses which have encryption certificate from the address
book, Email Encrypted TX and Digital Signature to Email can be used. When entering E-mail address from
the operation panel, you can not use these functions.
4 Set the sending size, original image, etc., as desired.
For the features that can be set, refer to the following:
➡ Custom Box (Send) (page 309)
To Next Page
Loading...
