Using Various Functions > Functions
383
Digital Signature to Email
[AdvancedSetup]
[Functions]
Add a digital signature to the email, using the electronic certificate.
By adding a digital signature to an email, you can confirm the identity of the destination and detect tampering
during transmission.
(Value: Off / On)
NOTE
To use this function, configure the certificate, protocol and email function in Command Center RX.
➡ Configuring S/MIME in Command Center RX (page 383)
Configuring S/MIME in Command Center RX
When using the Email Encrypted TX and Digital Signature to Email functions, make the following settings in
Command Center RX.
1
Access to Command Center RX.
➡ Accessing Command Center RX (page 116)
2
Register the device certificate which is used for S/MIME.
1 From the [Security Settings] menu, click [Certificates].
2 Click [Settings] of "Device Certificate" (1 to 5) to create or import the device certificate.
➡ Command Center RX User Guide
3 Click [Restart/Reset] > [Restart entire device] to restart the device.
3
Configure the protocol settings
1 From the [Network Settings] menu, click [Protocols].
2 Set [SMTP (E-mail TX)] and [S/MIME] of "Send Protocol" to [On].
3 Click [Submit].
4
Configure the E-mail function.
1 From the [Functions] menu, click [E-mail].
2 Configure the settings in "S/MIME Settings" as necessary.
➡ Command Center RX User Guide
3 Click [Submit].
To Next Page
Loading...
