Troubleshooting > Troubleshooting
616
Cannot send via SMB
Is the network cable connected?
Connect the cable to the Machine and HUB securely.
1
Connect the cable to the machine.
1 Connect the LAN cable to the network interface connector.
2 Connect the other end of the cable to the hub.
2
Power on the machine and configure the network.
➡ Network Setup (page 73)
Are the network settings on the machine configured correctly?
Check that TCP/IP is [On], and IPv4 or IPv6 is configured in accordance with the usage environment.
➡ TCP/IP SettingsTCP/IP Settings (page 479)
Are the SMB protocol and SMB settings for folder sending turned on?
1
Set the SMB protocol settings to On.
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [Protocol Settings] > [SMB Client
(Transmission)] > ON
2
Set the SMB settings for folder sending to [On].
[System Menu / Counter] key > [FunctionSettings] > [Sending Job - Folder] > [SMB Settings] > ON
To Next Page
Loading...
