Kyocera FS-1030MPF

2MH/2MJ/2MK/2ML
1-4-16
F000 Control PWB - Operation panel
PWB communication error
Defective har-
ness between
operation panel
PWB (YC1) and
control PWB
(YC7), or
improper con-
nector insertion.
Reinsert the connector. Also check for
continuity within the connector har-
ness. If none, remedy or replace the
harness.
Defective opera-
tion panel PWB.
Replace the operation panel PWB.
Defective control
PWB.
Replace the control PWB (See page 1-
5-37).
F020 Control PWB RAM checksum
error
Defective main
memory (RAM)
on the control
PWB.
Turn the power switch off/on to restart
the machine. If the error is not resolved,
replace control PWB (See page 1-5-37).
Defective
expanded mem-
ory (DIMM).
Replace the expanded memory
(DIMM).
F040 Control PWB engine communica-
tion error
A communication error is detected.
Defective control
PWB.
Turn the power switch off/on to restart
the machine. If the error is not resolved,
replace control PWB (See page 1-5-37).
F041 Control PWB - scanner PWB com-
munication error
A communication error is detected.
Defective control
PWB or scanner
PWB.
Turn the power switch off/on to restart
the machine. If the error is not resolved,
replace control PWB or scanner PWB
(See page 1-5-37 or 1-5-47).
F050 Control PWB engine checksum
error
Some error may
have occurred
when download-
ing the firmware
of the control
PWB.
Download the firmware of the control
PWB again (See page 1-6-1).
Defective control
PWB.
Turn the power switch off/on to restart
the machine. If the error is not resolved,
replace control PWB (See page 1-5-37).
F186 Control PWB video data control
error
Defective control
PWB.
Turn the power switch off/on to restart
the machine. If the error is not resolved,
replace control PWB (See page 1-5-37).
Code Contents
Remarks
Causes
Check procedures
/corrective measures