Special Paper
B-10
Specifications for each type of special paper are given below.
Colored Paper
Colored paper should meet the same specifications as listed for white bond paper in page B-3. In
addition, the pigments used in the paper must be able to withstand the heat of fusing during the
printing process.
Preprinted Paper
The paper base of preprinted paper should meet basic specifications. The preprinted ink must be able
to withstand the heat of fusing during the printing process, and do not use paper with any kind of
surface treatment, such as the type of paper commonly used for calendars.
Overhead Projection (OHP) Film
OHP film must be able to withstand the heat of fusing during the printing process. Specifications are
as follows.
OHP Film Specifications
Item Specification
Tolerance of heat Must tolerate at least 190°C (374°F)
Thickness 0.100 to 0.110 mm (3.9 to 4.3 mils)
Material Polyester
Squareness of corners 90° ±0.2°
Notes ___________________________________________________________________
• Feed OHP film one at a time from the manual tray.
• Do not use film made from anything other than polyester.
To Next Page
Loading...
